Switch -IEML[.][addr] - send archive by email

Attach an archive created or updated by the add command to email message. You need to have a MAPI compliant email client to use this switch (most modern email programs support MAPI interface).

You may enter a destination email address directly in the switch or leave it blank. In the latter case you will be asked for it by your email program. It is possible to specify several addresses separated by commas or semicolons.

If you append a dot character to -ieml, an archive will be deleted after it was successfully attached to an email.

If the switch is used when creating a multivolume archive, every volume is attached to a separate email message.